Replacement Gauge Hood
The gauge hood in my Miata has been scratched up since I bought it, but I knew there was a good chance it would break when I had to open …
Replacement Gauge Hood Read MorePosts
Speedometer Cable Replacement
1990-1997 Miatas use a mechanical speedometer cable that is spun by the transmission and routes through the engine bay to the back of the gauge cluster. These cables wear out …
Speedometer Cable Replacement Read More
RetroSound Grand Prix and Gauges – 3D Printed Surround
It’s always difficult to find a good looking modern radio that aesthetically fits an older car, which is why I was excited when RetroSound released the Grand Prix model. Until …
RetroSound Grand Prix and Gauges – 3D Printed Surround Read More
Flyin’ Miata NA/NB Dual Hood Lift Kit
This mod is mostly bling, but also gets the hood prop out of the way for working in the engine bay. Truthfully, I like to put the Miata’s hood up …
Flyin’ Miata NA/NB Dual Hood Lift Kit Read More
Differential Axle Seals
Replacing differential axle seals is not too daunting of a task. You will know if your axle seals need to be replaced if the spinning axles are splatter painting an …
Differential Axle Seals Read More
HVAC Panel Replacement
The temperature and fan control panel was looking yellowed from sun exposure. This is a super easy and cheap fix, because replacement reproduction panels are easy to find. The age …
HVAC Panel Replacement Read More
Back to OEM Washer Nozzles
After a few years with the fluidic washer nozzles, I decided to switch back to stock. The fluidic nozzles aim a little too high, I’ve heard they work better with …
Back to OEM Washer Nozzles Read More
How to Adjust Miata Trunk Torsion Springs
It is possible to adjust the torsion springs that hold the Miata trunk open. There are 3 strength settings depending on which slots the springs are in. Be careful not …
How to Adjust Miata Trunk Torsion Springs Read More
3D-Printed 14×7 RPF1 Center Caps
Enkei doesn’t make center caps for 14″ or 15″ RPF1 wheels. There are some options available for 15″ wheels (apparently Konig Helium center caps do the trick), and nice aftermarket …
3D-Printed 14×7 RPF1 Center Caps Read More
